Here's a "Custom Turn" on a technique many of you may already use to finish the outside edge of a facing. In this short tutorial I am demonstrating this method on the front facing of the Negroni Camp Shirt Pattern.
^ STEP 1 ^
The photo above shows the facing pattern cut out as usual on the CF edge (to the right), BUT cut about 1/8" wider on the curved outer edge (the edge my scissors are "pointing" to).
^ STEPS 2 & 3 ^
Next cut out your interfacing using THE CUT OUT FABRIC FACING PIECE for the INTERFACING "PATTERN" (I am using one of my custom-milled interfacings, Pro-Sheer Elegance Fusible Interfacing available exclusively at Fashion Sewing Supply).
Then, place the Interfacing and Fabric Facing piece RIGHT SIDES TOGETHER (the fusible side of the interfacing will be "up"), and stitch them together with an 1/8" seam along the curved edge. If you click the photo above to enlarge it, this stitching is more visible.
^ STEP 4 ^
Now, open up (separate the 2 layers), and move the piece to your pressing surface.
^ STEP 5 ^
At your pressing surface, turn the interfacing to the wrong side, WRAPPING the interfacing OVER and AROUND THE NARROW SEAM, enclosing the seam allowances. Now fuse the interfacing according to the instructions. Please note--The interfacing will not reach the long straight CF edge of the facing..and this is a good thing...no added bulk in that seam when it is later sewn !
The photo above shows the completed "Clean Finish" of this facing.
Usually when the basic method of this technique is used, the allowances of that little seam are completely turned to the wrong side, then the interfacing is fused to hold them down. However, when the seam-allowances are WRAPPED by the interfacing, they are not only clean finished, but thin and bulk-free. And the added bonus is that when the shirt is completely sewn, it will look like flat piping has been sewn to the facing edge. This is such a nice custom look without the bulk that would transfer to the right side as a wrinkle/ridge every time the shirt is pressed !
0 comments:
Post a Comment